Subject:
|
Re: Technic question: how to connect 2 technic beams
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Wed, 5 Oct 2005 06:00:50 GMT
|
Viewed:
|
3731 times
|
| |
|
|
In lugnet.technic, Jeff Shiner wrote:
| |
Ok... I have a question that may just show my ignorance... but I’ll ask
anyways.
I have a need to strongly connect two technic beams (one on top of each
other). Simply attaching them on top of each other (with Lego studs) is not
strong enough for my use. I am assuming that I need to somehow brace them
through the side holes but can not figure out how.
I need there to be just the two technic beams and can not space them with Lego
plates so I can not seem to strengthen them with liftarms as they don’t fit
nicely with just 2 beams. (ok... at least I don’t know how to make them fit).
Any of that make sense?
Any help would greatly appreciated.
- Jeff
|
put the two
one on top of the other.
On the middle of the top one put one  , on it one  and on it one .
The hole in the top can now be braced to the bottom beam with a  .
You can also put one of the below the beams, if it’s better for your application.
It’s bulky, but if that doesn’t bother you it’ll work.
HTH,
- David
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Technic question: how to connect 2 technic beams
|
| Ok... I have a question that may just show my ignorance... but I'll ask anyways. I have a need to strongly connect two technic beams (one on top of each other). Simply attaching them on top of each other (with Lego studs) is not strong enough for my (...) (19 years ago, 5-Oct-05, to lugnet.technic)
|
9 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
