| | Dave Schilling's pneumatic parlor trick
|
|
While at Brickfest I had the chance to meet Dave Schilling again. Dave is a very knowlegable technic/robotics builder. I also got the pleasure to meet his brother Phil. What a couple of nice guys. Dave showed me a pneumatic parlor trick that those (...) (19 years ago, 16-Aug-05, to lugnet.technic)
|
|
| | MOC's entered in BrickFest
|
|
(and whit's of Nanthan's MOC's whare in the race?....) Thanks for asking! I had 9 creations there- all as one MOC. I don't know if the telehandler was the closest vote or everthing together, but the telehandler got the most interest. I discovered (...) (19 years ago, 16-Aug-05, to lugnet.technic)
|
|
| | Re: Dual Hex small piston compressor (repost)
|
|
(...) While at Brickfest, Nathan shared his knowledge of radial engines with me. My future radial designs will have an odd number of evenly spaced pistons/pumps. I knew that one critical issue was that the piston shaft needs to point at the axle of (...) (19 years ago, 16-Aug-05, to lugnet.technic, lugnet.robotics)
|
|
| | Re: Brickfest winner Pneumatic Master
|
|
(...) Leg lift and leg drop are synchronized, but leg sweep was not. I did not have time to rebuild the body to provide identical leg sweep. Since this stopped the legs from completing their stride, I did not synchronize leg sweep. As Brickfest went (...) (19 years ago, 16-Aug-05, to lugnet.technic)
|
|
| | Re: Simplest steerable car chassis
|
|
(...) As I see this, it depends on what generation of "steering gear" elements you have. There are a number of different variants. You may even _not_ have some specialized steering elements. This will not make your task impossible, but a tad more (...) (19 years ago, 15-Aug-05, to lugnet.technic)
|