 | | Re: Parts specs —Thomas Avery
|
| | | (...) Terry, I'm not sure where this data is, I also recall seeing it somewhere. However, I have dial calipers and a micrometer, I'd be happy to make some measurements and post them. Do you know what parts your friend is looking to measure? Best, TJ (21 years ago, 12-Jul-03, to lugnet.technic)
|
| | | |
| | | | | Re: Parts specs —Terry Prosper
|
| | | | (...) Thanks TJ ! We want to do a plate with studs so a minifig can stand on it. Our idea is to drill holes the size of a technic hole so we can put technic half pins with stud on end in the holes. In order to do thatm we need the exact diameter of (...) (21 years ago, 14-Jul-03, to lugnet.technic)
|
| | | | |
| | | | | | Re: Parts specs —Thomas Avery
|
| | | | The following measurements (given in inches) were made with Starrett dial calipers. These are really made for 0.001" measurements, so that fourth decimal place isn't too accurate (say perhaps to the nearest +/- 0.0002"). Also, I measured 4 parts and (...) (21 years ago, 15-Jul-03, to lugnet.technic)
|
| | | | |
| | | | | | Re: Parts specs —Terry Prosper
|
| | | | (...) !!!!! Well, uh... A great big thank you is in order here :-) GREAT BIG THANK YOU !!!! That was everything I needed, I hope it can also help others! Terry (21 years ago, 16-Jul-03, to lugnet.technic)
|
| | | | |
