 | | Re: How I've been procrastinating...
|
|
(...) Very cool Dave! Nicely done. You should bring it to the next rtl dinner... ok, maybe with smaller tires for ease of transport ;) I can't figure out how you actually got the drive to the rear wheels. Is each of the new motors driving one of the (...) (23 years ago, 1-Aug-02, to lugnet.org.ca.rtltoronto, lugnet.technic)
|
| |
| | Znap-Snap Back to the drawing board
|
|
So there I am hang'n with my buddy Brian Sad, I was showing off my new Mecha Arm and the Znap Flex Axle snapped! Too bad, it was kind a cool set up. All we new was the arm was on the ground crawling around, and then the gears were just spinning. (...) (23 years ago, 1-Aug-02, to lugnet.technic)
|
| |
| | Re: New style diffs, driving rings and 16t clutch gears
|
|
(...) I've built a multi-function transmission/transfer-case for a Jeep. It includes a 4-speed transmission, which is then routed to a 2-speed transfer case. The 2-speed is exactly as ROSCO describes it. The output is then routed to the central (...) (23 years ago, 1-Aug-02, to lugnet.technic)
|
| |
| | Re: New style diffs, driving rings and 16t clutch gears
|
|
(...) I thought of a possible idea how you could use this as a means to make a car thats both a 2wd and a 4wd, where you select between them with a lever, much like on real 4wds. (23 years ago, 1-Aug-02, to lugnet.technic)
|
| |
| | Re: How I've been procrastinating...
|
|
(...) Added a few more pics of the 8466, scooting around the parking lot at work... (some action shots for y'all... ;) ) Dave K (23 years ago, 31-Jul-02, to lugnet.org.ca.rtltoronto, lugnet.technic)
|
