 | | Re: new group
|
|
(...) I thought that same thing early last year and tried to get a new group listed under robotics called .sensors After hearing all arguments against that, I started subscribing to the whole .robotics group and now do searches for posts including (...) (23 years ago, 30-Nov-01, to lugnet.technic)
|
| |
| | Bionicle book cancelled
|
|
AMazon just sent me email saying the Bionicle book has been cancelled. :( -gyug (23 years ago, 30-Nov-01, to lugnet.technic.bionicle)
|
| |
| | Technic A-10 Warthog
|
|
Hey gang, my latest creation is completed. With 3 technic motors, 1 micromotor, 3 fiberoptic banks, 4 large pneumatic cylinders, and 1 small pneumatic cylinder, this has a lot of nifty features. Check out the A-10 on the technic page. Thanks much (...) (23 years ago, 30-Nov-01, to lugnet.announce, lugnet.technic, lugnet.build.military) !!
|
| |
| | Re: new group
|
|
I agree. I think cranes are certainly part of Technic and I wouldn't like to check another group every time I check for new posts. - David (...) (23 years ago, 30-Nov-01, to lugnet.technic)
|
| |
| | Re: new group
|
|
(...) Well, you'd post to lugnet.admin.general asking for it, however I'm not sure it's really needed - what would you discuss there that can't be discussed in lugnet.technic? It's not exactly a high volume group, and most people reading it would (...) (23 years ago, 30-Nov-01, to lugnet.technic)
|
| |
| | Re: building thicker technic axles
|
|
(...) about (...) the (...) and (...) (URL)Also, the axle driving the rotor also had to bee strengthened. I put an axle (...) note the rotor axle was actually 2 joined axles, and extended about 10 studs without support. ROSCO (23 years ago, 30-Nov-01, to lugnet.technic)
|
| |
| | Re: new group
|
|
(...) Compartmentalized dork alert!! :-) Maggie C. (23 years ago, 30-Nov-01, to lugnet.technic, lugnet.off-topic.fun)
|
| |
| | new group
|
|
I would like to start a new group for technic cranes. Does anyone know how i would go about doing this? thanks Jared (23 years ago, 30-Nov-01, to lugnet.technic)
|
| |
| | Re: Joining Beams Axially at 90 deg
|
|
(...) One way might be to use the light gray half-pins (ldraw part 4274.dat). Put them in the endmost holes of the "sideways" beam. The short protruding sections can then act as top studs, and the two beams can be connected as you describe with a (...) (23 years ago, 30-Nov-01, to lugnet.technic)
|
| |
| | Re: building thicker technic axles
|
|
(...) same thing on the helicoptor rotor I've made. To counter this I made a 'one-direction'-drive that 'slipped' when the motor stooped. See (URL) (fifth item in list) and (URL) the axle driving the rotor also had to bee strengthened. I put an axle (...) (23 years ago, 29-Nov-01, to lugnet.technic)
|
