 | | Re: Concentric drive (was Re: genuinemodels.com down?)
|
|
(...) (URL) (Click for the LDraw file) The green bricks have axle holes with a stationary 12x axle running through. The drive input is to the z16 clutch gear at the top. The yellow and blue sections rotate in opposite directions at the same speed. (...) (19 years ago, 29-May-05, to lugnet.technic, FTX)
|
| |
| | Re: Concentric drive (was Re: genuinemodels.com down?)
|
|
(...) So what was the solution? Jude (19 years ago, 29-May-05, to lugnet.technic)
|
| |
| | Re: Concentric drive (was Re: genuinemodels.com down?)
|
|
(...) Bad form to reply to myself twice in the same thread, but I've figured out a solution. Wish it were a bit smaller, but that's life with limited gear geometries... --Bram (19 years ago, 29-May-05, to lugnet.technic)
|
| |
| | Re: genuinemodels.com down?
|
|
(...) Yes, it looks like the Telepresence site is down. (...) I think most 3 shaft implementations involve a differential (URL) passing through the centre of a large technic turntable (URL) and an axle through the centre of the diff (that is how Jen (...) (19 years ago, 29-May-05, to lugnet.technic)
|
| |
| | Concentric drive (was Re: genuinemodels.com down?)
|
|
(...) Specifically, I'm trying to come up with a way to have two pieces rotating in opposite direction along a stationary shaft which extends all the way through the mechanism. The drive for the rotating components should be on the stationary (...) (19 years ago, 29-May-05, to lugnet.technic)
|
