Subject:
|
Re: Concentric drive (was Re: genuinemodels.com down?)
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Sun, 29 May 2005 02:19:47 GMT
|
Viewed:
|
6927 times
|
| |
|
|
In lugnet.technic, Bram Lambrecht wrote:
> Specifically, I'm trying to come up with a way to have two pieces rotating in
> opposite direction along a stationary shaft which extends all the way through
> the mechanism. The drive for the rotating components should be on the
> stationary portion so it can be motorized.
Bad form to reply to myself twice in the same thread, but I've figured out a
solution. Wish it were a bit smaller, but that's life with limited gear
geometries...
--Bram
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Concentric drive (was Re: genuinemodels.com down?)
|
| (...) Specifically, I'm trying to come up with a way to have two pieces rotating in opposite direction along a stationary shaft which extends all the way through the mechanism. The drive for the rotating components should be on the stationary (...) (21 years ago, 29-May-05, to lugnet.technic)
|
8 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
