 | | Re: Has the technic "rotor" liftarm been discontinued or replaced?
|
|
(...) Argh... Why can't they make a service pack or something for these things... >> Mark (21 years ago, 31-Oct-03, to lugnet.technic)
|
| |
| | Re: Has the technic "rotor" liftarm been discontinued or replaced?
|
|
(...) with two of the 3-blade pieces, shown in the Fall 2003 catalog. However, after checking out (URL) I've noticed the online image for set 10072 does NOT inluce those two pieces. Hmm... -TJ (21 years ago, 31-Oct-03, to lugnet.technic)
|
| |
| | Re: Need Advice: Will 8366 RC Run on Carpet?
|
|
(...) Thanks Jennifer! I look forward to getting this set! -Paul D. (21 years ago, 31-Oct-03, to lugnet.technic)
|
| |
| | Re: Looking for Technic suggestions ...
|
|
"Jennifer Clark" <jen@vulture.dmem.strath.ac.uk> wrote in message news:HnIM5K.1nnz@lugnet.com... (...) [ ... snipped ... ] (...) Thanks to all for all of the positve feedback, I had a lot of fun building these. A number of clubs have used amusement (...) (21 years ago, 31-Oct-03, to lugnet.technic)
|
| |
| | Re: Has the technic "rotor" liftarm been discontinued or replaced?
|
|
According to Peeron it's only ever been used in one set: 3806 Gigamesh There are two other three blade rotors: 2712, with 1 stud and one hole per blade, 32125, with two studs per blade. Not sure if either one could do the job for you... Duq "Mark (...) (21 years ago, 30-Oct-03, to lugnet.technic)
|
| |
| | Has the technic "rotor" liftarm been discontinued or replaced?
|
|
If there's any ambiguity about the part to which I refer, here's a photo, from bricklink.com. (URL) cannot find any new source for these on either bricklink or ebay in sizeable quantity. Has it been replaced with another part that is more readily (...) (21 years ago, 30-Oct-03, to lugnet.technic)
|
| |
| | Re: Need Advice: Will 8366 RC Run on Carpet?
|
|
Are any of the racers faster than others? I've been thinking about the RC Race Buggy from 2002. I think a Racers FAQ I found on the Lego website said it was faster than others - but it didn't mention 2003 models. "Jennifer Clark" (...) (21 years ago, 30-Oct-03, to lugnet.technic)
|
| |
| | Re: Gyro- advanced biped
|
|
(...) Thanks, I'm glad you like it. On the subject of speed, you might want to check out my X5 biped. (URL) about three times as fast as Gyro, although it lacks the side to side stabilizing mechanism. (...) I didn't really think about that, but I (...) (21 years ago, 30-Oct-03, to lugnet.technic)
|
| |
| | Re: 8455 Alternate Model - Pneumatic Biped
|
|
(...) It takes very looong strides, but slowly. Not nearly as fast as pedmatic the small cylinder biped. Kevin (21 years ago, 30-Oct-03, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: Nice biped James
|
|
(...) (URL) Best regards, /Tobbe (URL) (remove SPAM when e-mailing) (21 years ago, 30-Oct-03, to lugnet.technic)
|
