|
|
 | | JoyBricx is updated
|
| Hi, all, I release new version of the JoyBricx. (URL) I make the program named JoyBricx for remote control (...) The new version support RCX/SCOUT, too. It can export the NQC program. Enjoy ! -- mac (23 years ago, 8-Feb-03, to lugnet.robotics, lugnet.robotics.rcx, lugnet.robotics.spybotics, lugnet.technic.bionicle)
| | | | | Re: Props for Hovercraft
|
| (...) Well I did a little test, heres the pics: (URL) that the propeller shaft is cylindrical, not "x" axle-shape, so friction is much greater than standard axle. It worked reasonably well, even with no lubrication and old batteries. I reckon with (...) (23 years ago, 7-Feb-03, to lugnet.technic)
| | | | | Re: Props for Hovercraft
|
| How about inserting the 24T gear into half a large turntable, and securing the other end of the turntable using axles. I know this gets very large where you don't want to get large, but it might provide stability in ways the other solutions do not. (...) (23 years ago, 7-Feb-03, to lugnet.technic)
| | | | | Re: Props for Hovercraft
|
| (...) Have you considered using lubricant between the 1x 4 beam and axle? I know I did, many times, but never got around to do it. Do you think it might reduce the friction enough? (23 years ago, 7-Feb-03, to lugnet.technic)
| | | | | Re: Props for Hovercraft
|
| Yes, I had tried that. I was unable to prevent all the rotation at the friction pin, and even a small amount of movement there caused significant wobble/binding. Mark Haye "Ross Crawford" <rcrawford@csi.com> wrote in message (...) (23 years ago, 7-Feb-03, to lugnet.technic)
|
|
