| | Re: Hoverfan (was: Re: Props for Hovercraft)
|
|
"Tobbe Arnesson" <StPnAtM@lotek.nu> wrote in message news:H9y1Ay.8Br@lugnet.com... all your designs tobbe are very inspiring with the same major problem as my propeller :( the like to explode because the are not locked that's why i used a rubber (...) (22 years ago, 7-Feb-03, to lugnet.technic)
|
|
| | Hoverfan (was: Re: Props for Hovercraft)
|
|
(...) my lunch hour, this was my best attempt: (URL) you can see it only has four blades but I could not make any more easily, I'm thinking about solutions though... I connected an old 9V motor underneath it and it holdes up just fine and blows a (...) (22 years ago, 7-Feb-03, to lugnet.technic)
|
|
| | Re: Just an idea for an prop for a hovercraft
|
|
"Øyvind Steinnes" <senniets@online.no> wrote in message news:H9wKLu.F5y@lugnet.com... (...) I (...) dont (...) the (...) hold (...) it seems i didn't read your post carefully enough sorry (...) oh G!!! so you should try to build the lifting (...) (22 years ago, 7-Feb-03, to lugnet.technic)
|
|
| | Re: Just an idea for an prop for a hovercraft
|
|
"pixel" <pixsrv@poczta.onet.pl> wrote in message news:H9vM7J.4ut@lugnet.com... (...) As I wrote I used the #20 / #21 panels. That is the panels that comes with the Williams F1, the other has a big hole in the midle and are too bulky. I testet both (...) (22 years ago, 6-Feb-03, to lugnet.technic)
|
|
| | Re: Props for Hovercraft
|
|
(...) No, it only has one pin hole, and no axle holes. Why LEGO decided to do it that way I can't imagine - all previous sets (AFAIK) used the offset axle holes (present in the old 24t gears) to connect pistons, not the pin holes. IMO that part is a (...) (22 years ago, 7-Feb-03, to lugnet.technic)
|