 | | Re: See X-Wing Fighter in Ldraw/Ldlite —Terry Keller
|
| | | (...) That is odd. It looks to me that the canopy has two clips similar to the clips on a "6019.dat Plate 1 x 1 with Clip Horizontal" piece that extend rearward. Those new pieces you mentioned look like they might have a " T " bar arrangement to (...) (26 years ago, 8-Jan-99, to lugnet.starwars)
|
| | | |
| | | | | Re: See X-Wing Fighter in Ldraw/Ldlite —James Brown
|
| | | | (...) Assuming they are the same pieces (no reason for them not to be) that are in the '99 Adventurer's sets, then they are 1x2 bricks with a horizontal side rod, as previously seen only on 1x2 plates. There is a similar 1x2 brick with a verticle (...) (26 years ago, 9-Jan-99, to lugnet.starwars)
|
| | | | |
| | | | | | Re: See X-Wing Fighter in Ldraw/Ldlite —Terry Keller
|
| | | | | (...) At the time I was writing that, I had that nagging feeling I was forgetting something. I forgot all about the 1x2 with vertical clip. The new piece you describe, with horizontal rod, sounds exactly like what it is. Although there still may be (...) (26 years ago, 9-Jan-99, to lugnet.starwars)
|
| | | | | |
| | | | | | Re: See X-Wing Fighter in Ldraw/Ldlite —Steve Bliss
|
| | | | (...) I don't think so. At least, not exactly. In the snowspeeder, the brick attaching to the canopy looks like it is a 1x2 brick. The 1x side goes to the canopy clip. So whatever special hardware is there, it has to go on the short-side of 1x2 (...) (26 years ago, 11-Jan-99, to lugnet.starwars)
|
| | | | |
