Subject:
|
Problems with Darth Vader Technic 8010
|
Newsgroups:
|
lugnet.starwars
|
Date:
|
Tue, 1 Jan 2002 05:55:18 GMT
|
Viewed:
|
322 times
|
| |
|
|
Just building the Dart Vader Technic and I have run into a few problems.
1st, the instructions show the body to be complete with just a post for the
head, but the head instructions show a rotating ball as the connection to
the body. How do I make this work. There are no obvious extra peices left
over. Am I not seeing it?
2nd, the arms have a short post extending from the bottom of the arm, about
midway up the arm. There seems to be no where for this to connect. Again,
am I losing it?
Any help is appreciated
|
|
Message has 1 Reply:
 | | Re: Problems with Darth Vader Technic 8010
|
| (...) The rotating ball has a cross-shaped hole on one end of it. The technic post or axle that protrudes from the shoulders. The post on the body goes in the hole on the rotating ball. I didn't have any trouble with my vader model, I hope you can (...) (23 years ago, 4-Jan-02, to lugnet.starwars)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
