 | | Re: lego changed molds (?) —Mark Neumann
| | | | I know others know much, much more on this subject than me, however; Lots of parts have had minor changes over the years. Take a look at any given piece from years ago and now and you should notice a few things. I just grabbed an inverted 2x2 slope (...) (23 years ago, 24-Feb-02, to lugnet.space)
| | | | | | | | | | Re: lego changed molds (?) —William R. Ward
| | | | | | (...) The thinner front studs make it possible to insert a peg into them, and also reduce the amount of ABS needed (thus reducing cost). The ribbing is common in a lot of newer bricks, and is probably also to reduce cost. (...) you wash them in (...) (23 years ago, 24-Feb-02, to lugnet.space)
| | | | | | | | | | | | Re: lego changed molds (?) —Steve Bliss
| | | | | (...) used to make the part codes, see (URL). That FAQ was written for LDraw part authors, but amongst the other questions, it addresses the coding issue. Steve (23 years ago, 26-Feb-02, to lugnet.space)
| | | | | | |
