 | | Re: failure in communicaton between RCX & IR Tower —Rob Hendrix
|
| | | "Elizabeth Mabrey" <emabrey@storming-robots.com> wrote in message news:HoMq73.B9J@lugnet.com... (...) I (...) ceased (...) I (...) OK, I have the problem fixed. You may not like the remedy, but it worked lastnight flawlessly. Oh, and the PCMCIA USB (...) (21 years ago, 26-Nov-03, to lugnet.robotics.rcx.robolab)
|
| | | |
| | | | | Re: failure in communicaton between RCX & IR Tower —Elizabeth Mabrey
|
| | | | Hey, Rob, that's what I was doing last night as well.. but I was installing the w2kpro as my virtual machine (VMWare). However, I ran into some system problem and I have to do this again today. If it works with the w2kpro on your toshiba satellite (...) (21 years ago, 26-Nov-03, to lugnet.robotics.rcx.robolab)
|
| | | | |
| | | | | | Re: failure in communicaton between RCX & IR Tower —Rob Hendrix
|
| | | | (...) fine (...) (all (...) Ya, its a real pain in the arse... Rob (21 years ago, 27-Nov-03, to lugnet.robotics.rcx.robolab)
|
| | | | |
| | | | | | Re: failure in communicaton between RCX & IR Tower —Elizabeth Mabrey
|
| | | | Just to verify the verdict... yes, it did work with w2kpro installed on this laptop. One note is that w2k vanilla does not support wireless 802.1g device, which is what comes with this toshiba satellite p25. It requires service pack 4. -- emabrey (21 years ago, 8-Dec-03, to lugnet.robotics.rcx.robolab)
|
| | | | |
