To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.rcx.pbforthOpen lugnet.robotics.rcx.pbforth in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / RCX / pbFORTH / 528
  RE: Displaying info while debugging
 
(...) Mario, I did some checking and I think the real issue is with the USB driver from LEGO. The serial tower does not exhibit this behaviour. It has its own problems, which include falling asleep after 2 seconds of inactivity. So, as far as I can (...) (22 years ago, 2-Jul-02, to lugnet.robotics.rcx.pbforth)
 
  Re: Displaying info while debugging
 
Thanks a lot Ralph, And I'm sure you're right. I tried this: 10000 VALUE CTR : test 100 0 DO I CR . CTR 0 DO LOOP LOOP ; For CTR > 11000, the numbers are displayed one at a time. Below 11000, they're displayed in batch. So, it probably means that (...) (22 years ago, 3-Jul-02, to lugnet.robotics.rcx.pbforth)
 
  Re: Displaying info while debugging
 
Here it is... : wait 15 0 timer_SET BEGIN 0 timer_GET 0= UNTIL ; I go with 0,15 seconds to be on the safe side; 0,10 seconds is too border line. So now, the first example becomes: : TEST 100 0 DO I CR . wait 7 1 0 MOTOR_SET LOOP 7 4 0 MOTOR_SET ; (...) (22 years ago, 3-Jul-02, to lugnet.robotics.rcx.pbforth)
 
  Re: Displaying info while debugging
 
Hi Ralph, I mentionned a while ago (see msg #508) that I have a problem with SAVE-SYSTEM. Could it be the same problem? Could it related to the USB driver and that, while saving the system, there is no period of inactivity and the buffer gets full (...) (22 years ago, 4-Jul-02, to lugnet.robotics.rcx.pbforth)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR