 | | CONSTANTS and VALUES in pbForth
|
|
(...) There are a couple of things in this note. One is an introduction to CREATE DOES> and the other is a solution to your actual problem. Basically, what CREATE DOES> does is separate the run-time and compile time semantics of a word. This is (...) (24 years ago, 24-May-00, to lugnet.robotics.rcx.pbforth)
|
| |
| | Re: Forth question
|
|
(...) You might want to try : zzz S" CONSTANT ONE" EVALUATE ; 1 zzz (...) I think VALUE can be used for that. Ernst (24 years ago, 24-May-00, to lugnet.robotics.rcx.pbforth)
|
| |
| | Re: How do I delete firmware from firmware?
|
|
(...) Great. Thanks. This is a real lifesaver since I am deleting and reloading firmware at a rapid rate and my RCX is inside a construction which makes it awkward to get at the batteries. Now the delete/reload can be done entirely at the GUI. (24 years ago, 24-May-00, to lugnet.robotics.rcx.pbforth)
|
| |
| | Re: Forth question
|
|
(...) Actually the various reasons are simple so I might as well state them. The serial port is not available at the time I want to create a constant because the serial port will be broken and therefor can't be used as the forth input stream. I am (...) (24 years ago, 24-May-00, to lugnet.robotics.rcx.pbforth)
|
| |
| | Re: Forth question
|
|
(...) I still want to create a constant from within a definition. I have an initializing word that will calculate the value of the constant. For various reasons I can't do this calculation except within the runtime behavior of the word. This is not (...) (24 years ago, 24-May-00, to lugnet.robotics.rcx.pbforth)
|
