 | | Re: time sampling under the rcx standard OS
|
|
(...) From what I've seen, the standard firmware takes about 3ms per command, and the same program will run on BrickOS about 100 times faster. I usually set up my BrickOS programs so they use the internal timer, and only update the motor setting (...) (19 years ago, 17-Sep-05, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: time sampling under the rcx standard OS
|
|
(...) Sorry, I didn't explain. This program only aims at checking the loop frequency capability of the rcx firmware, implementing a PWM. The rotation sensor is only used as a potentiometer knob, allowing me to determine by hand the PWM pulse as (...) (19 years ago, 19-Sep-05, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: time sampling under the rcx standard OS
|
|
(...) Well, in BrickOS, my loops usually execute at > 1kHz, so I usually just set it to check the sensor, and set the motor every 1ms. So it just keeps checking the clock. (...) Yes. There's an option that lets you download an "SREC" type of file. I (...) (19 years ago, 19-Sep-05, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: time sampling under the rcx standard OS
|
|
Hi Steve, As I'm quite new to BrickOS and to C programming, I'm sorry I'm not sure I understood what you meant, neither how you do this : (...) - Do you check the sensor at a higher rate, and only send a command to the motor at 1kHz ? - How do you (...) (19 years ago, 21-Sep-05, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: time sampling under the rcx standard OS
|
|
(...) Here's a code byte from my LegWay code. ---- int MotorSpeedArray[32] = {1,3,2,0}; // Speeds // ... later in the program... if (sys_time>CheckTime) // check system timer - is it time to check sensors again? { L1 = ReadSensor(SENSOR_1); L3 = (...) (19 years ago, 21-Sep-05, to lugnet.robotics.rcx.nqc)
|
