Subject:
|
Re: BricxCC release 3.3.3.7
|
Newsgroups:
|
lugnet.robotics.rcx.nqc
|
Date:
|
Fri, 15 Feb 2002 13:38:41 GMT
|
Viewed:
|
3456 times
|
| |
|
|
In lugnet.robotics.rcx.nqc, Matthias Jetleb writes:
> O.K. Well this is good news (sort of)
>
> Is anyone else's 3.3.3.7 claiming to be 3.3.3.5?
Whoops. I totally screwed that up. I apparently put an old EXE in the ZIP
file. I need to seriously improve my configuration management! :-)
Sorry about the mixup. I'm not going to release again until I'm sure I've
tracked down and fixed the slowness problem.
John Hansen
|
|
Message is in Reply To:
 | | Re: BricxCC release 3.3.3.7
|
| O.K. Well this is good news (sort of) I thought it was just me and my maxed-out P133 that had this problem. I sent an email to our favorite programmer on the weekend concerning it, but I was still not sure it was me. It appeared to me that the (...) (23 years ago, 11-Feb-02, to lugnet.robotics.rcx.nqc)
|
7 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
