 | | Re: Communication between NQC and VisualBasic
|
|
It seems that you want to run an RCX emulator on the PC side that can use the PC IR Tower as if it was the internal transmitter in the RCX brick. Thus you could run NQC generated bytecode in your robot, and NCQ generated bytecode on your PC. I know (...) (24 years ago, 30-Nov-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Communication between NQC and VisualBasic
|
|
I would like to experiment with communication between two autonomous robots. Unfortunately I can't afford a second RCX. So I would like to this thing with the RCX and my PC. Is there a way to write a NQC program that interacts with a Visual Basic (...) (24 years ago, 30-Nov-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: monitoring motor revolutions
|
|
(...) Hi Kris, In addition to Lester's comment here some ideas and statements regarding your project. As Lester stated, you will need accurate distance, speed and direction measurements - and that is so true. Furthermore, for calculating coordinates (...) (24 years ago, 29-Nov-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: monitoring motor revolutions
|
|
(...) The type of navigation you seem to be talking about is called "dead reconning" by aviators. This method requires accurate distance, speed and direction mesurments. Counting motor revolutions does not even tell distance if the surface has (...) (24 years ago, 28-Nov-00, to lugnet.robotics.rcx.nqc)
|
| |
| | monitoring motor revolutions
|
|
I am currently working on a program that will monitor where a RCX goes. I am trying to establish a coordinate system so if it finds a light it can tell the location of the light. I was thinking about monitoring motor revolutions, but then I am (...) (24 years ago, 28-Nov-00, to lugnet.robotics.rcx.nqc)
|
