 | | Re: Problems with USB Tower
|
|
look at the patch here: (...) (21 years ago, 21-Jul-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Please Help?! Problems with installing LegOS on WinXP
|
|
You might try following my instructions: (URL) recommend using the pre-built hitachi tools which you can download via the link in the document referenced above. Let me know if you have any questions. John Hansen (URL) (21 years ago, 19-Jul-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Please Help?! Problems with installing LegOS on WinXP
|
|
(...) Tyler, You can check to see what Cygwin packages have been installed on your system by using the cygcheck command at the cygwin command prompt. Try cygcheck -c If the output is too large for your dos window you can export it to a file by using (...) (21 years ago, 19-Jul-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Please Help?! Problems with installing LegOS on WinXP
|
|
(...) If you haven't installed 'make', there is *no way* you successfully built the compiler. If you go back to the URL you quoted, you will see make is listed as one of the required Cygwin packages to install. Re-run Cygwin setup.exe, install make, (...) (21 years ago, 19-Jul-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Please Help?! Problems with installing LegOS on WinXP
|
|
(...) Hi Ed, Thanks for replying. In (URL) Hitachi H8 cross-compiler was built in: c:\cygwin\build I'm assuming that's where it is. Also, what is the "make" command? Bash in cygwin cant seem to find it. Thanks Tyler. (21 years ago, 19-Jul-03, to lugnet.robotics.rcx.legos)
|
