|
|
 | | Re: 1.0 brick not responding
|
| (...) Yes, it flashes. (...) Yes it did work, but it's been in storage for a couple of years. (...) At this point, just download firmware. Once I get the communication issues resolved, I'll do programming. (...) (19 years ago, 13-Sep-05, to lugnet.robotics.rcx)
| | | | | Re: RCX to RCX NQC
|
| On Mon, September 12, 2005 8:03 pm, Brian Davis wrote: ... (...) ... Somewhere in there, it tells you the RCX will not accept the same command twice in a row. Each command has two op codes that are 8 digits apart. So (I think) for SetWatch you (...) (19 years ago, 13-Sep-05, to lugnet.robotics.rcx)
| | | | | RCX to RCX NQC
|
| In a semi-followup to Steve's earlier "remote battery tester"... While the standard firmware provides almost no way to get bytes into the RCX (other than "Message()", one byte at a time), it can certainly export them ("SendSerial"). And it occured (...) (19 years ago, 13-Sep-05, to lugnet.robotics.rcx)
| | | | | Re: 1.0 brick not responding
|
| (...) Tammy, A couple questions... 1) Does the light on the IR tower flash when you're trying to communicate? 2) Did it ever work (did it work before, but stop, or is this the first time you've tried communicating?) 3) What are you trying to (...) (19 years ago, 12-Sep-05, to lugnet.robotics.rcx)
| | | | | 1.0 brick not responding
|
| mac powerbook 5300 communicates with the IR tower, but no response from the brick. palm 130 with pbrick, also no response from the brick. The brick powers on and beeps, just no communication with the powerbook or the palm for programming. Since it (...) (19 years ago, 12-Sep-05, to lugnet.robotics.rcx)
|
|
