 | | Re: Extending IR communications
|
|
Hello all. The mirror trick works for sending the signals from the IR tower to the RCX (I'm only using a single RCX). However, the return signal the RCX wants to send to the tower isn't transmitted across the mirror. Since you mentioned leJOS and (...) (19 years ago, 8-Aug-05, to lugnet.robotics.rcx)
|
| |
| | Re: Question - VB programming of RCX
|
|
(...) Sure. And VC++ and VC#. And now .NET (...) It was here (URL) (19 years ago, 8-Aug-05, to lugnet.robotics.rcx)
|
| |
| | Re: Question - VB programming of RCX
|
|
(...) I don't know of many people who use VB to actually program the RCX. It is very possible to do, however, it's not like you may think. You can write a PC program in VB that will send the commands (a program) to the brick, but you still have to (...) (19 years ago, 8-Aug-05, to lugnet.robotics.rcx)
|
| |
| | Re: Extending IR communications
|
|
In terms of power requirements and battery life, has anyone here actually quantified how much of a difference that makes? Its a damn good idea - as long as you have white, and relatively flat ceilings. If you dont want/are not able to reposition (...) (19 years ago, 6-Aug-05, to lugnet.robotics.rcx)
|
| |
| | Question - VB programming of RCX
|
|
Hi, Are there people who program there RCX with Visual Basic (VB)? If so, where can i find info about that? I do have VB5. Regards, Ludo (19 years ago, 7-Aug-05, to lugnet.robotics.rcx)
|
| |
| | RE: Extending IR communications
|
|
Orient both RCXs so that they are pointing towards the ceiling. Set the RCX transmit power level to high (default is probably low power); there's probably some Lejos function to do this -- all it requires is setting one bit in an I/O register to 1. (...) (19 years ago, 5-Aug-05, to lugnet.robotics.rcx)
|
| |
| | Re: Extending IR communications
|
|
(...) Have you tried a mirror? Infrared light IS light ! (19 years ago, 5-Aug-05, to lugnet.robotics.rcx)
|
| |
| | Re: Errors compiling threads
|
|
(...) Hi Steve, Thanks, you were right about the compiler being ok. I changed "pid_t" to "tid_t" and got the thread statements working correctly. Finally, by consulting BrickOS documentation I found out the new syntax for the old "sys_time" command (...) (19 years ago, 4-Aug-05, to lugnet.robotics.rcx.legos)
|
| |
| | Re: ScriptEd - Question
|
|
(...) Check the line before that. Your code says: // direction_ // direction of monorail const delay1=1500 // minimum stop time in station (10 seconds) const delay2=3000 // maximum stop time in station (30 seconds) // I'm not sure exactly what (...) (19 years ago, 4-Aug-05, to lugnet.robotics.rcx)
|
| |
| | Re: ScriptEd - Question
|
|
(...) Hi Steve, I see the message apearing in the status bar, but it's an error! Error is : Error (0xe0050801) from VPBrick compiler The error apears in following line: const delay1 = 1000 // minimum stop time in station (10 seconds) The word (...) (19 years ago, 4-Aug-05, to lugnet.robotics.rcx)
|
