Subject:
|
Motor LEDs not illuminated
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 23 Oct 1996 18:33:00 GMT
|
Original-From:
|
Greg Starr <STARR@nomorespamUNM.EDU>
|
Viewed:
|
2667 times
|
| |
|
|
In building a Handyboard, all was well until the Motor Output Circuit.
When running testmotor() none of LED1-8 illuminate. The LED polarity is
correct, the debuggin steps in the manual seem to check out.
I've built a 6.270 board successfully before so I _think_ I know what I'm
doing, but I'd sure appreciate any suggestions!
*****************************************************************
* Greg Starr, Professor and Graduate Advisor *
* Department of Mechanical Engineering ph (505) 277-6298 *
* University of New Mexico, Albuquerque NM 87131 FAX 277-1571 *
* email- starr@unm.edu WWW- http://pliers.unm.edu/~starr/ *
*****************************************************************
|
|
Message has 1 Reply:
2 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
