 | | downloading pcode
|
|
Hi everyone, Need some help downloading pcode. Have a row of black squares right now and have tried several different computers with the same 'wrong port or board mode.' I'm sure its in the bootstrap mode and also have replaced the MAX232 chip on (...) (23 years ago, 8-Feb-01, to lugnet.robotics.handyboard)
|
| |
| | Re: downloading pcode
|
|
Hi -- it might be driver issues on the Windows site. Please go through the debug instructs at (URL) let us know where you stand after the HyperTerminal test. Fred In your message you said: (...) (23 years ago, 8-Feb-01, to lugnet.robotics.handyboard)
|
| |
| | Re: downloading pcode
|
|
After the Hyperterminal test I found that the loopback portion of the test failed. I have checked the continuity on each line of the phone cable and it looks good. As mentioned before the MAX232 chip on the Interface board has been replaced. I will (...) (23 years ago, 10-Feb-01, to lugnet.robotics.handyboard)
|
| |
| | Re: downloading pcode
|
|
Brian, I had the same problem with a board I built. It turned out to be the memory was bad. I would check all the solder connections to the memory socket and make sure that it is seated properly. -DAN (...) (23 years ago, 12-Feb-01, to lugnet.robotics.handyboard)
|
| |
| | Re: downloading pcode
|
|
Make sure that your phone wire between the HB and interface board has four wires, most generic phone wires only have two wires in them. -Dan (...) and (...) MAX232 (...) I (...) any (...) (23 years ago, 12-Feb-01, to lugnet.robotics.handyboard)
|
