| |
Hi everyone,
Need some help downloading pcode. Have a row of black squares right now and
have tried several different computers with the same 'wrong port or board
mode.' I'm sure its in the bootstrap mode and also have replaced the MAX232
chip on the interface board with no luck. The only other possible problem I
can think is one of the chips on the Handyboard. Can anyone suggest a
testing procedure or chip that could be bad? I would greatly appreciate any
help.
thanks, brian
|
|
Message has 2 Replies:
 | | Re: downloading pcode
|
| Hi -- it might be driver issues on the Windows site. Please go through the debug instructs at (URL) let us know where you stand after the HyperTerminal test. Fred In your message you said: (...) (24 years ago, 8-Feb-01, to lugnet.robotics.handyboard)
| | | Re: downloading pcode
|
| Brian, I had the same problem with a board I built. It turned out to be the memory was bad. I would check all the solder connections to the memory socket and make sure that it is seated properly. -DAN (...) (24 years ago, 12-Feb-01, to lugnet.robotics.handyboard)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
