 | | Exp. board Servo
|
| Hi.. i have some questions about the exp. board and R/C servo, hope anyone can help me.. thanks.. From the "Expansion board software" homepage, it said that servo0=(value) is used to control the servo, may i ask how can i convert this value to (...) (25 years ago, 29-Feb-00, to lugnet.robotics.handyboard)
| | | | | Re: Exp. board Servo
|
| (...) Well, since it seems these values often vary from servo to servo I usually set them by using the knob function and scaling it down so I can visually see the numbers I'm putting into it and the result on the servo; turning it until it chatters (...) (25 years ago, 29-Feb-00, to lugnet.robotics.handyboard)
| | | | | Re: Exp. board Servo
|
| (...) Fortunately there is a direct relationship between servo-value and angle. Try different angles (for example 0 / 45 / 90 / 135 / 180 degree) and draw the diagram value vs. angle (for example with MS Excel). You will (hopefully) see a linear (...) (25 years ago, 1-Mar-00, to lugnet.robotics.handyboard)
| |
