| |
Hi.. i have some questions about the exp. board and R/C servo, hope anyone can
help me.. thanks..
From the "Expansion board software" homepage, it said that servo0=(value) is
used to control the servo, may i ask how can i convert this value to "degree" ?
i.e. if i want to turn the servo to 0 deg, 30 deg, 60 deg...etc.. what value
should I input ?? Thanks for your help...
|
|
Message has 1 Reply:
 | | Re: Exp. board Servo
|
| (...) Well, since it seems these values often vary from servo to servo I usually set them by using the knob function and scaling it down so I can visually see the numbers I'm putting into it and the result on the servo; turning it until it chatters (...) (25 years ago, 29-Feb-00, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
