Subject:
|
Re: Charge polarity on each board opposite?
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 5 Sep 1996 13:36:24 GMT
|
Original-From:
|
Fred G. Martin <fredm@media.=stopspam=mit.edu>
|
Viewed:
|
1589 times
|
| |
| |
> I use dl on a DOS 286, which does the CONFIG register automatically I
> thought. In any case, I tried using dl -eeprom config0c.s19, with the
> same results.
right; randy sargent's dl does automatically check the config and burn
it if it's wrong. so your config is probably okay.
> The dl of pcode_hb.lis runs nominally, but the LCD remains
> all black across the top row, bottom row blank, and ic won't synchronize
> with the Handyboard.
wait; you mean "pcode_hb.S19," right?
when it downloads it doesn't give any errors? but the pcode still
won't run.
try removing the LCD screen before download and run the pcode with the
screen removed. if the board is otherwise okay you will hear a
repetitious clicking when attempting to run the pcode.
in general when i see the row of all black on the LCD, it does
indicate some kind of power problem. i would try measuring system
voltage, make sure there is +5v on Vcc pins; see if any chips are
getting hot; try pulling chips to see if the "all black" goes away.
-Fred
>
> Is anyone doing repairs on these boards? I'm all ready to write code to
> interface the Vector 2X compass via the SPI port and I trash the system.
> Prabal, you still out there?
>
> :-)
>
> -mike
>
>
> * Michael L. Ross/C33 | Lockheed Engineering & Sciences Co.****
> * Robotics Department | 2400 Nasa Rd. 1, Houston, TX 77058*****
> *(713)333-7094 voice,(713)333-6071 fax*#include <disclaimer.h>*
> * Finger me for my public key. mross@outland.jsc.nasa.gov ****
> * If you weren't a socialist in your twenties, you had no heart.
> * If you weren't a conservative by your thirties, you have no brain.
>
>
|
|
Message is in Reply To:
| | Re: Charge polarity on each board opposite?
|
| (...) Fred, I use dl on a DOS 286, which does the CONFIG register automatically I thought. In any case, I tried using dl -eeprom config0c.s19, with the same results. The dl of pcode_hb.lis runs nominally, but the LCD remains all black across the top (...) (28 years ago, 5-Sep-96, to lugnet.robotics.handyboard)
|
7 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|