Subject:
|
Re: Help needed!
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 28 Mar 1999 17:28:17 GMT
|
Original-From:
|
Will Bain <willbain@cs#Spamcake#.umt.edu>
|
Viewed:
|
970 times
|
| |
| |
MSMKatz wrote:
<snip>
> After this, the following messages appear on my pc:
> "synchronizing with board"
> "pcode version 3.10 present on board"
> "loading c:\system\icw32\libs\lib_hs.lis"
> "loading c:\system\icw32\libs\lib_hb.c"
> "loading c:\system\icw32\libs\r22_ir.lis"
> "loading c:\system\icw32\libs\r22_ir.icb"
> "loading c:\system\icw32\libs\r22_ir.c"
> "initializing interrupts"
>
> After this last message, nothing.. The pc keeps waiting for a signal
> from the Handy Board that isn't there and I have to abort IC.
<snip>
Marc, I wonder if the hardware is perfectly ok, but you're inadvertently
attempting to load the wrong software. I'm not sure where your
lib_hs.lis came from or why IC automatically loads it, but I think it
might be loading the wrong libraries. I was under the impression that
the r22 files listed above were for the MIT 6.270 controller board or
the Rug Warrior board (I can't remember which).
When I start up IC, it automatically loads the files listed in
lib_hb.lis, of which there are only two:
Synchronizing with board
Pcode version 3.10 present on board
Loading D:\PROGRAMS\IC\libs\lib_hb.lis.
Loading D:\PROGRAMS\IC\libs\lib_hb.c.
Loading D:\PROGRAMS\IC\libs\lib_hb.icb.
Initializing interrupts
Downloading 1142 bytes (addresses 8000-8475): 1142 loaded
Downloading 40 bytes (addresses 8476-849D): 40 loaded
Downloading 16 bytes (addresses 849E-84AD): 16 loaded
Code loaded.
This seems to work fine on my Handy Board; perhaps you could try this on
yours and let us know if that solves the problem. Best of luck to you!
-- Will
, ,
__@_/ \_@__ |/
| /__, o @_/
)\ ) ( \ (\/\\,
~~~~~~~~~ ' ` ~~~~~~~~~~~ ` ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Wendy Parson, I can't take a
Will Bain, well-tanned person seriously.
& Tatoosh --Cleveland Amory
|
|
Message is in Reply To:
| | Help needed!
|
| Hi, I have assembled my recently bought Handy Board kit and have run into major problems: In paragraph 6.0.5 of the assembly manual, the Handy Board is tested for the microprocessor and memory circuits. After powering up the board and running IC (...) (26 years ago, 28-Mar-99, to lugnet.robotics.handyboard)
|
6 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|