To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 5628
    electronics question please help —Bob Kelly
   Hello all, I hope there is a simple answer for this... I have attempted to build the circuit that will allow IR object detection using the Sharp IR detector module and a pair of "high output" infrared LEDs. The circuit I built was the one from (...) (26 years ago, 22-Feb-99, to lugnet.robotics.handyboard)
   
        Re: electronics question please help —Nick Taylor
     Bob - - Here is a link to the 74HCT04 data sheet: (URL) that this helps. - - - Nick - - - Bob Kelly wrote: <snip> (...) (26 years ago, 22-Feb-99, to lugnet.robotics.handyboard)
   
        Re: Visual Basic and parallel port —Chen Yung Hsu
     i know that this doesn't really have anything to do with the handyboard but has anyone tried to access the computer's parallel port with visual basic? =) chen (26 years ago, 22-Feb-99, to lugnet.robotics.handyboard)
   
        Re: electronics question please help —Eric Noyau
     (...) Been there, done that! Funny. I bought almost all the same stuff from my local shack. Writting the software was the easy part ;^). (...) I've supplied some power to the inverter, yes. I'm assuming it's mandatory to have the inverter actually (...) (26 years ago, 22-Feb-99, to lugnet.robotics.handyboard)
    
         Re: electronics question please help —Nick Taylor
     Eric - - You might try shielding the IR sensor ... add successive layers of "Scotch" tape until you get the desired sensitivity. I'm using layers of black plastic trash bags ... it blocks a lot of visible light, but very little IR. - - - Nick - - - (...) (26 years ago, 23-Feb-99, to lugnet.robotics.handyboard)
   
        Re: electronics question please help —K.L.McKinnon
   The modulation frequency of the IR diodes must match the sensor (depending on exact part number, around 38 KHz) within +/- 3 KHz. As you move away from the center frequency, detection drops off sharply. Are you able to confirm the modulation (...) (26 years ago, 23-Feb-99, to lugnet.robotics.handyboard)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR