Subject:
|
Bootstrap download mode
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sat, 5 Sep 1998 06:32:53 GMT
|
Original-From:
|
edmund <ho106@singnet.com.&stopspammers&sg>
|
Viewed:
|
1139 times
|
| |
| |
Hi
I have been trying to get the HB into bootstrap mode without much
success. Following the instructions in the manual, I held down the
STOP button while turning on the HB. The red and green LEDs were
supposed to turn on for a short period of time and then turn off
completely. However, no matter how much I try, the green LED remained
on (from the moment I connected the battery packs to the HB) and the
red LED wasn't even on for this whole period. I'm really at my wits
end now. Can someone help me out?
Btw, I'm using using ICwin 3.1 . I have the MS-Dos version of 2.8 (i
think) too.
thanks,
Edmund
PS. what is the red PWR LED on the serial interface board for?
|
|
Message has 2 Replies: | | Re: Bootstrap download mode
|
| see if you can get it to go into download mode when you don't have the phone cable plugged in. if this works, then you have some kind of probl with your serial connection. make sure you have a normal modem cable, and a telephone style RJ11 cable (...) (26 years ago, 4-Sep-98, to lugnet.robotics.handyboard)
| | | bootstrap mode in assembling the HB
|
| hi At present I am up to section 4.4, "serial line and stop switch". I have installed all the components as per the section but when testing by applying power and holding down the stop switch, the HB will not go into bootstrap mode. I have not (...) (26 years ago, 9-Sep-98, to lugnet.robotics.handyboard)
|
4 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|