Subject:
|
LMD18200
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 8 Apr 1998 21:14:36 GMT
|
Original-From:
|
Michael S. Reiling <macman@SPAMLESSinreach.com>
|
Viewed:
|
1565 times
|
| |
|
|
I just bought the motor driver kit from wirz electronics, and I have
finished putting it all together. My question is, do I take the motor
drivers off of the HB and put them on the wirz board, or do I leave them on
the HB.
Question 2: Assuming I have figured out #1(see above) where do I connect
the wirz board to? Should I be using the servo routines, or does it plug
in where the motor drivers on the HB go?
Thanks everyone,
Mike
|
|
Message has 3 Replies:
 | | Re: LMD18200
|
| <FontFamily><param>Courier New</param>We've used the Wirz boards with great success here at Washington University. I can answer both of your questions at once, since they're the same thing. YES. Take the drivers off the handyboard, because now the (...) (27 years ago, 8-Apr-98, to lugnet.robotics.handyboard)
| | | Re: LMD18200
|
| Oh yeah, just use the regular motor IC routines. Plug and play! -=Scott Date sent: Wed, 8 Apr 1998 14:14:36 -0700 To: handyboard@media.mit.edu From: "Michael S. Reiling" <macman@inreach.com> Subject: LMD18200 (...) (27 years ago, 8-Apr-98, to lugnet.robotics.handyboard)
| | | Re: LMD18200
|
| I think I am a little confused by the wording of this. I am using the non-bridged board, so 1 socket on the HB controls how many boards? Thanks for all your help. Really appreciate it! Mike ---...--- <excerpt><fontfamily...param>YES. Take the (...) (27 years ago, 9-Apr-98, to lugnet.robotics.handyboard)
|
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
