To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 3593
3592  |  3594
Subject: 
Re: LMD18200
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Wed, 8 Apr 1998 22:32:03 GMT
Original-From: 
Scott Mitchell Simon <sms7@arl.wustl+SayNoToSpam+.edu>
Reply-To: 
Scott Simon <sms7@arlSPAMLESS.wustl.edu>
Viewed: 
4179 times
  
Oh yeah, just use the regular motor IC routines.  Plug and play!

-=Scott


Date sent:      Wed, 8 Apr 1998 14:14:36 -0700
To:             handyboard@media.mit.edu
From:           "Michael S. Reiling" <macman@inreach.com>
Subject:        LMD18200

> I just bought the motor driver kit from wirz electronics, and I have
> finished putting it all together. My question is, do I take the motor
> drivers off of the HB and put them on the wirz board, or do I leave them
> on the HB.
> 
> Question 2:  Assuming I have figured out #1(see above) where do I connect
> the wirz board to?  Should I be using the servo routines, or does it plug
> in where the motor drivers on the HB go?
> 
> Thanks everyone,
> Mike
> 
> 



Message is in Reply To:
  LMD18200
 
I just bought the motor driver kit from wirz electronics, and I have finished putting it all together. My question is, do I take the motor drivers off of the HB and put them on the wirz board, or do I leave them on the HB. Question 2: Assuming I (...) (29 years ago, 8-Apr-98, to lugnet.robotics.handyboard)

6 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR