Subject:
|
Expected 141, Received 91, After 60 chars received
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 9 Dec 1997 06:40:55 GMT
|
Original-From:
|
Michael D. McGargle <mcgargle@SPAMCAKEcenturyinter.net>
|
Viewed:
|
718 times
|
| |
| |
I am assembling a Handy Board and I am getting the above error when I
try to download the pcode_hb.s19 using dl (dl pcode_hb.s19 -port com1).
I have just finished assembling section 6.0.4. Everything seems to have
been working up to this point. I have checked for proper orientation of
componants, cold solder joints, solder bridges, etc. and found no
problem. I do have a CMOS ram chip that is labeled MCM60L256AP10 (.vs.
62256) and I was wondering if that could be the wrong memory.
Any suggestions as to where to start looking? I have a beat up old
multi-meter here and I could get to an O-scope if I had to (going back
to a former employer's workbench) but that is a ways from here.
Help! Give me some direction to go in please!
Mike McGargle
|
|
Message has 1 Reply:
3 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|