Subject:
|
Re: Expected 141, Received 91, After 60 chars received
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 9 Dec 1997 16:34:48 GMT
|
Original-From:
|
Mike McGargle <mcgargle@centuryinter.%SayNoToSpam%net>
|
Reply-To:
|
mcgargle@centuryinter#NoMoreSpam#.net
|
Viewed:
|
657 times
|
| |
|
|
Sorry,
I'm running DOS 6.22 on an old Compaq 386 SX25. I've built one other board
with this machine as the host, but I did download the latest IC zip file.
Fred G. Martin wrote:
> what is your OS. If you are using Win31/Win95, try HBDL.EXE instead
> of DL.
>
> fred
>
> In your message you said:
> > I am assembling a Handy Board and I am getting the above error when I
> > try to download the pcode_hb.s19 using dl (dl pcode_hb.s19 -port com1).
> >
> > I have just finished assembling section 6.0.4. Everything seems to have
> > been working up to this point. I have checked for proper orientation of
> > componants, cold solder joints, solder bridges, etc. and found no
> > problem. I do have a CMOS ram chip that is labeled MCM60L256AP10 (.vs.
> > 62256) and I was wondering if that could be the wrong memory.
> >
> > Any suggestions as to where to start looking? I have a beat up old
> > multi-meter here and I could get to an O-scope if I had to (going back
> > to a former employer's workbench) but that is a ways from here.
> >
> > Help! Give me some direction to go in please!
> >
> > Mike McGargle
> >
> >
--
I am Bill of Micro$oft. You will be assimilated.
Resistance is futi*&^%$#@
THIS PROGRAM HAS PERFORMED AN ILLEGAL OPERATION
AND WILL BE SHUT DOWN.
|
|
Message is in Reply To:
3 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
