Subject:
|
Re: Expected 141, Received 91, After 60 chars received
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 9 Dec 1997 13:19:16 GMT
|
Original-From:
|
Fred G. Martin <fredm@mediaSTOPSPAMMERS.mit.edu>
|
Viewed:
|
732 times
|
| |
| |
what is your OS. If you are using Win31/Win95, try HBDL.EXE instead
of DL.
fred
In your message you said:
> I am assembling a Handy Board and I am getting the above error when I
> try to download the pcode_hb.s19 using dl (dl pcode_hb.s19 -port com1).
>
> I have just finished assembling section 6.0.4. Everything seems to have
> been working up to this point. I have checked for proper orientation of
> componants, cold solder joints, solder bridges, etc. and found no
> problem. I do have a CMOS ram chip that is labeled MCM60L256AP10 (.vs.
> 62256) and I was wondering if that could be the wrong memory.
>
> Any suggestions as to where to start looking? I have a beat up old
> multi-meter here and I could get to an O-scope if I had to (going back
> to a former employer's workbench) but that is a ways from here.
>
> Help! Give me some direction to go in please!
>
> Mike McGargle
>
>
|
|
Message has 1 Reply:
Message is in Reply To:
3 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|