Subject:
|
Re: Serial Device Interfacing
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Mon, 27 Oct 1997 18:41:56 GMT
|
Original-From:
|
Tom Brusehaver <TOMB@AUGUSTA.NETPERCEPTIONS.saynotospamCOM>
|
Viewed:
|
1735 times
|
| |
|
|
B> It will be used to control a LM197x digital Attenuator which has a
B> 3 wire serial interface.
B> Is it possible to wiggle the output lines in such a way ? Any
B> hints ?
If it is a 3 wire interface, does this imply synchronous? That sounds
like the SPI port. Nothing too it, check on the V2X compass code I
did. Also there is some other SPI code in the contributed software
section of the new layout.
|
|
Message is in Reply To:
 | | Serial Device Interfacing
|
| OK Newbie Allert !!! I'm looking at the Handy Board as a major step up from the Basic Stamp 2, but I need to be able to send out serial messages from the digital outputs. On the BS2 it is declared as a ShiftOut instruction. It will be used to (...) (27 years ago, 27-Oct-97, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
