 | | RE: Wireless Communication with HB —Ross, Mike
| | | | Are you wanting to transmit an analog signal, e.g. faster/slower, such as most people do with a joystick, or some other purpose? Did you want the PC to generate the signal, or a standard RC transmitter receiver? I've used the HB Input Capture line (...) (27 years ago, 27-Oct-97, to lugnet.robotics.handyboard)
| | | | | | | | | | Serial Device Interfacing —Bill Coghill
| | | | | OK Newbie Allert !!! I'm looking at the Handy Board as a major step up from the Basic Stamp 2, but I need to be able to send out serial messages from the digital outputs. On the BS2 it is declared as a ShiftOut instruction. It will be used to (...) (27 years ago, 27-Oct-97, to lugnet.robotics.handyboard)
| | | | | | | | | | | | Re: Serial Device Interfacing —Tom Brusehaver
| | | | | B> It will be used to control a LM197x digital Attenuator which has a B> 3 wire serial interface. B> Is it possible to wiggle the output lines in such a way ? Any B> hints ? If it is a 3 wire interface, does this imply synchronous? That sounds like (...) (27 years ago, 27-Oct-97, to lugnet.robotics.handyboard)
| | | | | | |
