| | running .s19 Luke
| | | Hello, I am trying to use normal .asm files assembled with as11 on the handy-board. I am not using IC. Although my .s19 file downloads fine I don't think it is being run. My code begins at $D000. I use an ORG statement to set $BFFE:$BFFE to $D000. (...) (28 years ago, 19-Feb-97, to lugnet.robotics.handyboard)
| | | | | | | | Re: running .s19 Fred G. Martin
| | | | | does your program to anything else other than attempt to leave special mode? You could have it write a value to the motor address ($7000); that would be a more visible indication that it is running. BTW, why is your first instinct to take it out of (...) (28 years ago, 19-Feb-97, to lugnet.robotics.handyboard)
| | | | | | | | | | Re: running .s19 Matt Harlan
| | | | | shouldn't you be going into expanded mode, not single chip? (...) (28 years ago, 19-Feb-97, to lugnet.robotics.handyboard)
| | | | | | |