 | | start_process question....
|
|
I am writing a program based mainly on Fred Martin's book. The code is prety close to his program, but when I try to load I keep getting the following error codes, "attempt to use <int> as an array", and, "too many argumentd given to , (...) (22 years ago, 13-May-02, to lugnet.robotics.handyboard)
|
| |
| | is it possible to use the lego vision command with the handyboard?
|
|
I'm interested in using the lego vision command with my handyboard. But it seems to use a (usb) port. So is there a way to use a (usb) with the handyboard? And has anyone ever attempted to hack the lego vision command for their handyboard? Also does (...) (22 years ago, 4-May-02, to lugnet.robotics.handyboard)
|
| |
| | external power source with expansion board
|
|
Hi, I know this has been asked before, but I was unable to find a deffinitive answer. I cut the trace on my handy board in order to externally power some larger dc motors with two 6 volt gel cell packs wired in series for 12 volts. Unfortunately, (...) (22 years ago, 2-May-02, to lugnet.robotics.handyboard)
|
| |
| | Re: Robot Positioning using Beacons
|
|
Would a HandyCricket be good for driving the beacons? "Chris Steiger" <csteiger@comcast.net> wrote in message news:GvGHKu.2wr@lugnet.com... (...) the (...) (22 years ago, 1-May-02, to lugnet.robotics.handyboard)
|
| |
| | Re: Robot Positioning using Beacons
|
|
That sounds good, but what do I use to drive each beacon, (e.g. send out the coded IR signal and sonar ping). Using a full blown microcontroller like the handyboard for each one would be incredibly expensive and wasteful. I only need a controller (...) (22 years ago, 1-May-02, to lugnet.robotics.handyboard)
|
