| | Re: Is Expansion Board Servo Voltage Suppose to Be 9v
|
|
Do you have the dropping 2n540x diodes in place? they should drop the 9.6v batt to the 5-6v servo voltage. Fred (...) (23 years ago, 15-Aug-01, to lugnet.robotics.handyboard)
|
|
| | Is Expansion Board Servo Voltage Suppose to Be 9v
|
|
Hello again, I was surprised to find that my expansion board servo ports were putting 9 volts. Is this the way the board was designed or is this in error. Most servos I have come across work in the upper 4 to 6 volt range. The servo I have runs (...) (23 years ago, 15-Aug-01, to lugnet.robotics.handyboard)
|
|
| | Help Needed With Serial Output Drivers Syntax
|
|
Does anyone have an example of how to use the 7i9600 serial driver with the Scott Edwards SSC II. I cannot seem to find any documentation. Thanks, Andy Loy andyl@citlink.net (23 years ago, 14-Aug-01, to lugnet.robotics.handyboard)
|
|
| | Re: Problem in Battery Power
|
|
Hi Chee, I have been told the power still needs to be supplied from that connector. My idea was to only use two of the four connecting pins (one for plus and one for minus) downward from the expansion board and solder two female connectors (one for (...) (23 years ago, 14-Aug-01, to lugnet.robotics.handyboard)
|
|
| | Problem in Battery Power
|
|
Hi ! I am a research student in Robotic. I am using Handy Board together with Expansion Board to interface with DC motors and other sensory devices. Unfortunately, internal power supply is not adequate for powering my motors. So, I am thinking to (...) (23 years ago, 14-Aug-01, to lugnet.robotics.handyboard)
|