| |
Hi !
I am a research student in Robotic. I am using Handy Board together with
Expansion Board to interface with DC motors and other sensory devices.
Unfortunately, internal power supply is not adequate for powering my motors.
So, I am thinking to cut the thick motor power trace, and then plugging a
secodary power devices into battery power jacks.
But, the battery power jacks have been accupied by Expansion Board's pins.
How do I suppy the external power to my DC motors in this situation? Does
the Expansion Board be affected when the power traced is cut?
Can you offer any suggestions. And your help is very much be appreciated.
Thank you.
Regards;
Chee
|
|
Message has 1 Reply:
 | | Re: Problem in Battery Power
|
| Hi Chee, I have been told the power still needs to be supplied from that connector. My idea was to only use two of the four connecting pins (one for plus and one for minus) downward from the expansion board and solder two female connectors (one for (...) (23 years ago, 14-Aug-01, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
