Subject:
|
Re: Is Expansion Board Servo Voltage Suppose to Be 9v
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 15 Aug 2001 02:41:18 GMT
|
Viewed:
|
1810 times
|
| |
|
|
Do you have the dropping 2n540x diodes in place? they should drop the
9.6v batt to the 5-6v servo voltage.
Fred
On Tuesday, August 14, 2001, at 09:56 PM, Andrew Loy wrote:
> Hello again,
> I was surprised to find that my expansion board servo ports were
> putting
> 9 volts. Is this the way the board was designed or is this in error.
> Most
> servos I have come across work in the upper 4 to 6 volt range. The
> servo I
> have runs uncomfortably hot when using the expansion board (and the
> standard
> 9.6v battery, in other words in not using a secondary power supply).
>
|
|
Message has 1 Reply:
Message is in Reply To:
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
