|
|
 | | Shaft Encoder for Handy Board.
|
| Hi there! We have three handy board controllers in our lab. We use it as our mobile robot's controller. Now, we want to add feedback motor control routine and required us to use shaft encoder. I just want to know, the model of the shaft encoder that (...) (23 years ago, 4-Aug-01, to lugnet.robotics.handyboard)
| | | | | HB for sale
|
| MOVING, gotta go... FOR SALE: Handy Board, Serial interface w/ battery charger; computer connector; misc elements from senosor/motor kit (including all 4 motors, most sensors); Interactive C license key ALL for $200 or best offer Excellent condition (...) (23 years ago, 28-Jul-01, to lugnet.robotics.handyboard)
| | | | | IRQ and XIRQ pins on handyboard
|
| Hello everybody, Is it a reason why the IRQ pin of the 68HC11 is not available. On the schema, seems that this pin is always up. If I look in the pcode.asm, the interrupt vector for IRQ ($BFF2) is set to RTI (BadInt) So, if I need to link a device (...) (23 years ago, 27-Jul-01, to lugnet.robotics.handyboard)
| | | | | LMD18200
|
| Hi, I have a question about the PCB that Matt Harlan have made for an LMD18200 H-Bridge. In that PCB seems that the Thermal Flag Output of the chip goes directly out and ready to connet to the HB, but this output will not be, in the case of set, of (...) (23 years ago, 27-Jul-01, to lugnet.robotics.handyboard)
| | | | | Re: Any success running IC with W2000 on notebook?
|
| Hi Steve, I have been running IC version 3.2 without any problems on W2k. Not on a notebook though. You can obtain a personal version of IC 3.2 from NetwtonLabs (www.newtonlabs.com/ic) for $35. Good luck, Willem van Asperen "Steve Mosiman" (...) (23 years ago, 25-Jul-01, to lugnet.robotics.handyboard)
|
|
