 | | Handyboard execution/operation speed
|
|
Hey all: How fast does the HandyBoard with the standard interactive C libraries execute standard IC instructions? What about the software system interrupt at 1kHz and the multitasking overhead, how do they play into things? I know float instructions (...) (26 years ago, 10-Mar-01, to lugnet.robotics.handyboard)
|
| |
| | Request: I2C Bus Handy Board interface Info.
|
|
In 1999 someone requested information on how to interface I2C and the Handyboard. I would like to revisit that request. Any information on components and code to use would be appreciated. Andrew P. Loy andyl@citlink.net aloy1@utk.edu (26 years ago, 9-Mar-01, to lugnet.robotics.handyboard)
|
| |
| | Re: Drill Motor
|
|
Yes, it can be used to control a drill motor, but probably not directly. It can drive 9V motors at 1 AMP (i think, depending on which h-bridge chips you have). I'm sure a drill motor will draw more than 1 amp, so you will need to use external power (...) (26 years ago, 7-Mar-01, to lugnet.robotics.handyboard)
|
| |
| | Drill Motor
|
|
Hi, All. I'm new to the list, but I was wondering if the handy board could be used to control something like a 7.2V cordless drill that you could get from Home depot? (26 years ago, 7-Mar-01, to lugnet.robotics.handyboard)
|
| |
| | Re: serial line problems
|
|
Tim, Please try the serial loopback test noted at (URL) will verify your cables and the comms path back from the HB to your PC. Fred In your message you said: (...) (26 years ago, 5-Mar-01, to lugnet.robotics.handyboard)
|
