 | | Re: About HAndy board and PIC
|
|
Hi, Sorry for taking me so long to reply... I was busy working on projects... Actually, I am not a good person to ask all these questions. I am also just getting started on this.... I want to first refer you to another site: (URL) This page contains (...) (26 years ago, 15-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Sonar Pictures?
|
|
Joe! Here's another pic of the sonar interface to the HB. Note that there are two ways to connect the sonar to the HB. One approach is to use the control lines to the L293 motor driver chip and the other is the SPI port. I've included both. Note (...) (26 years ago, 15-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Sonar Pictures?
|
|
(...) Try this picture: (URL) This shows the cap soldered in and pretty much hooked up. Hope this helps -Jim Munro <jimmn@xnet.com> (26 years ago, 14-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Sonar Pictures?
|
|
Does anyone have pictures of their sonar assembly online that I could look at, just to make sure everything is where it should be? My sonar is still hovering around one reading (today it's 1300, the other day it was 700) no matter where an obstacle (...) (26 years ago, 14-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Re: DC motor question
|
|
(...) [snip] (...) Bingo. Put .1uf caps (rated at least 4X your max voltage) from the (+) pole to the can, from the (-) pole to the can and from the (+) to the (-) pole. Keep your leads as short as possible. Put a big cap (1000uf+) on the power (...) (26 years ago, 14-Apr-00, to lugnet.robotics.handyboard)
|
