|
|
 | | Re: DC motor question
|
| (...) [snip] (...) Bingo. Put .1uf caps (rated at least 4X your max voltage) from the (+) pole to the can, from the (-) pole to the can and from the (+) to the (-) pole. Keep your leads as short as possible. Put a big cap (1000uf+) on the power (...) (24 years ago, 14-Apr-00, to lugnet.robotics.handyboard)
| | | | | DC motor question
|
| Hi, I am using DC Motors for the first time (previously used stepper motors) and have been experiencing difficulties when first powering on the handyboard. When I first turn on the power, occasionally the motors start up at full speed for no (...) (24 years ago, 14-Apr-00, to lugnet.robotics.handyboard)
| | | | | Re: Eltec 442-3
|
| (...) Perhaps you could waggle it back & forth (on a servo or something) to simulate motion. -- Will +---...---+ | ^^ <^ ^> | | / òó ó°° \ | | / =Y= U \ | | Wendy, Will, Tatoosh & Tenzing | +---...---+ The difference between reality and fiction? (...) (24 years ago, 13-Apr-00, to lugnet.robotics.handyboard)
| | | | | Re: Eltec 442-3
|
| (...) Move the sensor, or the bot. If you sweep right to left you will detect the heat in front of you. -- Eric (24 years ago, 13-Apr-00, to lugnet.robotics.handyboard)
| | | | | Eltec 442-3
|
| Hi all I just recieved a new Eltec Pyroelectric sensor from acroname and have been messing around with it on my bot. In the booklet it says that the sensor is a Human Motion detector as apposed to a human presence detector. when there is a heat (...) (24 years ago, 13-Apr-00, to lugnet.robotics.handyboard)
|
|
