Subject:
|
Eltec 442-3
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 13 Apr 2000 20:13:39 GMT
|
Original-From:
|
glashan <{lynneg@mweb.}SayNoToSpam{co.za}>
|
Viewed:
|
762 times
|
| |
|
|
Hi all
I just recieved a new Eltec Pyroelectric sensor from acroname and have been
messing around with it on my bot.
In the booklet it says that the sensor is a Human Motion detector as apposed
to a human presence detector.
when there is a heat source directly in front of it, it reads 128 from
analog(), but the same value is returned when there is absolutely no heat.
Does anybody know how i could get get it to tell the difference between heat
/ no heat??
Thanks
Ross
|
|
Message has 2 Replies:
 | | Re: Eltec 442-3
|
| (...) Perhaps you could waggle it back & forth (on a servo or something) to simulate motion. -- Will +---...---+ | ^^ <^ ^> | | / òó ó°° \ | | / =Y= U \ | | Wendy, Will, Tatoosh & Tenzing | +---...---+ The difference between reality and fiction? (...) (24 years ago, 13-Apr-00, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
