 | | Re: Vector 2X driver
|
|
Yes, I run my Vector 2X is slave mode using only IC. I don't worry about missing the last bit since the precision of the heading is only +- 2 deg. It's very simple to code up. -Scott (...) (25 years ago, 16-Mar-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Non-polaroid Sonar
|
|
Thanks for your help :-D Just so I'm clear, ref pink book page 10-17. Does the "bit_set( 0x1021, 1 );" refer to bit 0 -EDG3B, and bit_clear( 0x1021, 2 ); " refer to bit 1 -EDG3A. This is what was throwing me, I always thought bits started at zero (...) (25 years ago, 16-Mar-00, to lugnet.robotics.handyboard)
|
| |
| | Re: windows nt and handyboard
|
|
I am also using the icwin from newton labs and that works fine also. Although I have not tried it under win2k, which I must do soon. --peter (...) (25 years ago, 16-Mar-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Overcharge Battery
|
|
Im going to jump in here on this one and give an opinion. C/10 for a NiCd is a little much for a trickle charge. C/10 on NiCd's is usually considered more of a trimming type of charge following a higher charge rate of C or C/2 to put the bulk of the (...) (25 years ago, 16-Mar-00, to lugnet.robotics.handyboard)
|
| |
| | Re: windows nt and handyboard
|
|
(...) Actually I am working with Linux, but I gave it a try and it worked just fine. I tested with MS Windows NT Workstation 4.0 Service Pack 5. Just open a command prompt and use this ic-version. (URL) There is no admin-account needed. Perhaps you (...) (25 years ago, 16-Mar-00, to lugnet.robotics.handyboard)
|
