 | | Re: Distance Sensors
|
|
Hi Raj, Your range of interest is small, but see if you can get anything out of the Sharp IR sensors from Acroname ((URL) luck! (...) ______ ______ ---...--- |_ _| |_ _| Kam Leang | |______| |______ University of Utah | |_ _| |_ _| Department of (...) (25 years ago, 25-Jan-00, to lugnet.robotics.handyboard)
|
| |
| | Distance Sensors
|
|
Hi All: Does anyone know of any good mini distance measuring sensors which can be used with a microprocessor? The required range is 0-30 mm and small size. Names of distributors would be greatly appreciated. Thank You. Raj (25 years ago, 25-Jan-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Handy Board Not Responding
|
|
It is possible to overcharge the HB only if you use the Serial Interface & Battery Charger board switched into Zap charge mode. Zap charge mode will fully charge the HB battery in three hours, after which point the battery will overheat and could (...) (25 years ago, 25-Jan-00, to lugnet.robotics.handyboard)
|
| |
| | Handy Board Not Responding
|
|
I was using the handy board when it ran out of power. I decided to charge the board for 14 hours but I actually left it charging for 17 hours. Afterwards I tried downloading the pcode_hb.s19 into the board to make sure it would work. Unfortunately I (...) (25 years ago, 25-Jan-00, to lugnet.robotics.handyboard)
|
| |
| | lugnet.off-topic.test
|
|
This is a test (25 years ago, 25-Jan-00, to lugnet.robotics.handyboard)
|
